4-FOLD BINARY OUTPUT FA1

4-fold KNX binary output for switching and control of loads. Mounting in distribution board on EN 60715 rail (4 modular units, each 18 mm). To be used in KNX installations for home and building automation.

ON/OFF switching of individual loads or groups of loads
Configurable as normally open or normally closed switch , Logical gates and forced mode for each channel , Manual control by levers (also without bus voltage) , Status feedback of output channels through the position of the levers , Block function for each channel , Time scheduling: switching delay for on and off, staircase lighting function with warning signal , Integration in scenarios
Operating hours counter configurable via bus

8-FOLD BINARY OUTPUT FB1

4-fold KNX binary output for switching and control of loads. Mounting in distribution board on EN 60715 rail (4 modular units, each 18 mm). To be used in KNX installations for home and building automation.

 On/off switching of individual loads or groups of loads
Configurable as normally open or normally closed switch , Logical gates and forced mode for each channel , Manual control by levers (also without bus voltage) , Status feedback of output channels through the position of the levers , Block function for each channel
• Time scheduling: switching delay for on and off, staircase lighting function with warning signal
Integration in scenarios , Operating hours counter configurable via bus

8-FOLD BINARY OUTPUT FB1/4-FOLD BLIND ACTUATOR FE1

8-fold KNX binary output 16(10)A for switching and control of loads or 4-fold KNX actuator for control of drives for motorized blinds, shutters or curtains. Mounting in distribution board on EN 60715 rail (4 modular units, each 18 mm). To be used in KNX installations for home and building automation.

ON/OFF switching of individual loads or groups of loads , Configurable as normally open or normally closed switch , Logical gates and forced mode for each channel , Manual control by membrane pushbuttons  , Status feedback of output channels through LEDs , Switching pushbutton manual/automatic mode , Block function for each channel , Time scheduling: switching delay for on and off, staircase lighting function with warning signal , Integration in scenarios
Operating hours counter configurable via bus

(BLIND ACTUATOR)
Full up and down run , Partial run with stop position from 0 to 100% of the length of the run , Position setting (change during the operation of the preset position) , Adjust the inclination of the slats (for blinds) , Integration in scenarios , Automatic control for protection against direct sunlight
Automatic control for protection against weather conditions (rain, wind, frost)

16-FOLD BINARY OUTPUT FB1/8-FOLD BLIND ACTUATOR FF1

16-fold KNX binary output 16(10)A for switching and control of loads or 8-fold KNX actuator for control of drives for motorized blinds, shutters or curtains. Mounting in distribution board on EN 60715 rail (8 modular units, each 18 mm). To be used in KNX installations for home and building automation.

BINARY OUTPUT
ON/OFF switching of individual loads or groups of loads , Configurable as normally open or normally closed switch , Logical gates and forced mode for each channel , Manual control by membrane pushbuttons  , Status feedback of output channels through LEDs , Switching pushbutton manual/automatic mode , Block function for each channel , Time scheduling: switching delay for on and off, staircase lighting function with warning signal , Integration in scenarios
Operating hours counter configurable via bus

BLIND ACTUATOR

Full up and down run , Partial run with stop position from 0 to 100% of the length of the run , Position setting (change during the operation of the preset position) , Adjust the inclination of the slats (for blinds) , Integration in scenarios , Automatic control for protection against direct sunlight
Automatic control for protection against weather conditions (rain, wind, frost)